LEG!!

Here I have a leg that I attemted to make over the skeleton and joints to see how well it would move instead of just moving/showing the skeleton or cylinders.


A little pulling here and a little scaling there. :]

Even more moving here, and even more rotating there...


Although the leg did end up 'OK'... because the leg is in three parts, the areas between each section of the leg do not blend with eachother and is easy to see where each part meet. (Not what I want) :(


Here I came to realise that when the knee joint bends, the knee itself pops out of place and this is because of where the joint rotates compared to that part of the leg. However even though I understand that the problem is, I still coudn't figure out a way of fixing this because the leg looks 'allright' when straight. Same goes for the ankle joint.... also.. NOT WHAT I WANT! :'(


Short vid that might show the problem I faced when bending the leg joints more clearer.